IS25LE01G-RILA3-TY datasheet(165/186 Pages) ISSI

Numer części	IS25LE01G-RILA3-TY

Szczegółowy opis	SERIAL FLASH MEMORY 133/104MHZ MULTI I/O SPI & QUAD I/O QPI DTR INTERFACE WITH ON-CHIP ECC

PDF	186 Pages

Scroll/Zoom	100%

Producent	ISSI [Integrated Silicon Solution, Inc]

Strona internetowa	http://www.issi.com

Logo

165 / 186 page

IS25LE01G

IS25WE01G

Integrated Silicon Solution, Inc.- www.issi.com

165

Rev. A6

01/14/2025

8.64 GANG SECTOR/BLOCK UNLOCK OPERATION (GBUN, 98h)

The Gang Sector/Block Unlock (GBUN) instruction provides a quick method to clear all DYB (Dynamic Protection

Bit)

bits to “1” at once.

Before the GBUN (98h) command can be accepted by the device, a Write Enable (WREN) command must be

issued and decoded by the device, which sets the Write Enable Latch (WEL) in the Status Register to enable any

write operations.

The sequence of issuing GBUN instruction is: drive CE# low → send GBUN instruction code → drive CE# high.

The instruction code will be shifted into the device on the rising edge of SCK.

The GBUN command is accepted in both SPI and QPI mode. The CE# must go high exactly at the byte boundary,

otherwise, the instruction will be ignored and not be executed. While the GBUN operation is in progress, the Status

t is “1” during the GBUN

operation, and is “0” when it is completed.

Figure 8.140 Gang Sector/Block Unlock Sequence In SPI Mode

Instruction = 98h

CE#

SCK

Mode 3

Mode 0

High Impedance

Figure 8.141 Gang Sector/Block Unlock Sequence In QPI Mode

98h

CE#

SCK

IO[3:0]

Mode 3

Mode 0

IS25LE01G-RILA3-TY Arkusz danych(PDF) 165 Page - Integrated Silicon Solution, Inc