Datasheet

www.rohm.com

TSZ02201-0RFR0G200530-1-2

© 2015 ROHM Co., Ltd. All rights reserved.

8/34

6.July.2015 Rev.001

TSZ22111･15･001

LM393xxx

LM2903xx

LM339xx

LM2901xx

Description of Electrical Characteristics

Described below are descriptions of the relevant electrical terms used in this datasheet. Items and symbols used are also

shown. Note that item name and symbol and their meaning may differ from those on another manufacturer’s document or

general document.

1. Absolute maximum ratings

Absolute maximum rating items indicate the condition which must not be exceeded. Application of voltage in excess of absolute

maximum rating or use out of absolute maximum rated temperature environment may cause deterioration of characteristics.

(1) Supply Voltage (Vcc

Indicates the maximum voltage that can be applied between the positive power supply pin and negative power

supply pin without deterioration or destruction of characteristics of internal circuit.

Indicates the maximum voltage that can be applied between non-inverting and inverting pins without damaging the

IC.

Indicates the maximum voltage that can be applied to the non-inverting and inverting pins without deterioration or

destruction of electrical characteristics. Input common-mode voltage range of the maximum ratings does not assure

normal operation of IC. For normal operation, use the IC within the input common-mode voltage range characteristics.

The operating temperature range indicates the temperature range within which the IC can operate. The higher the

ambient temperature, the lower the power consumption of the IC. The storage temperature range denotes the range

of temperatures the IC can be stored under without causing excessive deterioration of the electrical characteristics.

Indicates the power that can be consumed by the IC when mounted on a specific board at ambient temperature 25°C(normal

package (maximum junction temperature) and the thermal resistance of the package.

2. Electrical characteristics

Indicates the voltage difference between non-inverting pin and inverting pins. It can be translated into the input

voltage difference required for setting the output voltage at 0 V.

Indicates the difference of input bias current between the non-inverting and inverting pins.

Indicates the current that flows into or out of the input pin. It is defined by the average of input bias currents at the

non-inverting and inverting pins.

Indicates the amplifying rate (gain) of output voltage against the voltage difference between non-inverting pin and

inverting pin. It is normally the amplifying rate (gain) with reference to DC voltage.

Indicates the current that flows within the IC under specified no-load conditions.

Indicates the input voltage range where IC normally operates.

Signifies the voltage range that can be output under specific output conditions.

Indicates the current that flows into the IC under specific input and output conditions.

Denotes the maximum current that can be output from the IC under specific output conditions.

Response time indicates the delay time between the input and output signal which is determined by the time

difference from the fifty percent of input signal swing to the fifty percent of output signal swing.