|
1 Product Features
Fully compliant with JEDEC eMMC 5.0 Standard (JESD84-B50)
153-ball BGA, 0.5mm pitch
11.5 x 13mm, RoHS compliant
MLC NAND base technology
Multiple MLC or enhanced/reliable mode partitions user configurable according to eMMC Spec 5.0
High performance eMMC 5.0 specification
o Eleven-wire bus (clock, Data Strobe, 1 bit command, 8 bit data bus) and a hardware reset
o Three different data bus width modes: 1-bit (default), 4-bit, and 8-bit
o Clock frequencies 0-200MHz, High Speed Mode HS400
o Up to 250MB/s sequential read and up to 90MB/s sequential write in MLC mode
Power Supply: (Low-power CMOS technology)
o VCCQ 1.7V…1.95V or 2.7V…3.6V eMMC supply
o VCC 2.7V…3.6V NAND Flash supply
Optimized FW algorithms
o Power-fail data loss protection
o Wear Leveling technology
Equal wear leveling of static and dynamic data. The wear leveling assures that dynamic data as
well as static data is balanced evenly across the memory. With that the maximum write
endurance of the device is guaranteed
o Read Disturb Management
The read commands per region are monitored and the content is conditionally refreshed when
critical levels have occurred
o Auto Read Refresh
The interruptible background process maintains the user data for Read Disturb effects or Retention
degradation due to high temperature effects
o Diagnostic features with Device Health Report according to eMMC Spec 5.0, and new Firmware
FW2 with detailed Lifetime Monitor data.
o Field Firmware update according to eMMC Spec 5.0
o Discard and Sanitize, Trim
o Boot Operation Mode and Alternative Boot Operation Mode
o Replay Protected Memory Block (RPMB)
High reliability
o Designed with sophisticated firmware architecture for industrial and embedded markets.
o Ideal for application like POS/POI, PLC, IoT, gaming, medical and use as general boot medium for
embedded applications.
o The product is optimized for long life cycle that requires superior data retention as well as power
fail safety.
o Intensive write applications should use the enhanced/reliable mode
o Industrial Temperature range, -40° up to 85°C
Controlled BOM & PCN process
3 Product Description
The Swissbit eMMC is a managed non-volatile storage consisting of a single chip MMC controller and a NAND
flash memory chip inside a JEDEC defined standard BGA package. It is specially designed as a small form factor
memory product for storage of data and as a boot media. The performance is optimized to a mostly read
operation mode at low power consumption. The utilization of MLC NAND technology, with the option to
configure the memory in reliable mode, targets higher demanding industrial applications, which is supported
by the industrial temperature grade specification.
The eMMC controller directly manages NAND flash, including ECC, wear-leveling, IOPS optimization and read
sensing. The EM-20 firmware features support high throughput for large data transfers and performance for
small random data more commonly found in code usage. It also contains several security features as well as
multiple boot partitions. For read intensive applications the EM-20 uses advanced refresh features for
retention optimization.
eMMC communication is based on an advanced 11-signal bus. The communication protocol is defined as a part
of the JEDEC eMMC standard and referred to as the eMMC mode.
|