M95160-RDS3T datasheet(7/40 Pages) STMICROELECTRONICS

7 / 40 page

7/40

M95160, M95080

CONNECTING TO THE SPI BUS

These devices are fully compatible with the SPI

protocol.

All instructions, addresses and input data bytes

are shifted in to the device, most significant bit

first. The Serial Data Input (D) is sampled on the

first rising edge of the Serial Clock (C) after Chip

Select (S) goes Low.

All output data bytes are shifted out of the device,

most significant bit first. The Serial Data Output

(Q) is latched on the first falling edge of the Serial

Clock (C) after the instruction (such as the Read

from Memory Array and Read Status Register in-

structions) have been clocked into the device.

Figure 4. shows three devices, connected to an

MCU, on a SPI bus. Only one device is selected at

a time, so only one device drives the Serial Data

Output (Q) line at a time, all the others being high

impedance.

Figure 4. Bus Master and Memory Devices on the SPI Bus

Note: The Write Protect (W) and Hold (HOLD) signals should be driven, High or Low as appropriate.

AI03746D

Bus Master

(ST6, ST7, ST9,

ST10, Others)

SPI Memory

Device

SDO

SDI

SCK

CQD

SPI Memory

Device

CQD

SPI Memory

Device

CQD

CS3

CS2

CS1

SPI Interface with

(CPOL, CPHA) =

(0, 0) or (1, 1)

HOLD

M95160-RDS3T Arkusz danych(PDF) 7 Page - STMicroelectronics

M95160-RDS3T Arkusz danych(HTML) 7 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Arkusz danych Pobierz

Link URL