AD5546 datasheet(22/32 Pages) AD

22 / 32 page

AD5429/AD5439/AD5449

Rev. 0 | Page 22 of 32

Software LDAC Function

Load and update mode can also function as a software update

function, irrespective of the voltage level on the LDAC pin.

MICROPROCESSOR INTERFACING

Microprocessor interfacing to this family of DACs is via a serial

bus that uses standard protocol compatible with microcon-

trollers and DSP processors. The communications channel is

a 3-wire interface consisting of a clock signal, a data signal, and

a synchronization signal. The AD5429/AD5439/AD5449

require a 16-bit word with the default being data valid on the

falling edge of SCLK, but this is changeable via the control bits

in the data-word.

ADSP-21xx to AD5429/AD5439/AD5449 Interface

The ADSP-21xx family of DSPs is easily interfaced to this

family of DACs without the need for extra glue logic. Figure 47

is an example of an SPI interface between the DAC and the

ADSP-2191M. SCK of the DSP drives the serial data line, DIN.

SYNC is driven from one of the port lines, in this case SPIxSEL.

SCLK

SCK

SYNC

SPIxSEL

SDIN

MOSI

ADSP-2191*

*ADDITIONAL PINS OMITTED FOR CLARITY

AD5429/AD5439/

AD5449*

Figure 47. ADSP-2191 SPI to AD5429/AD5439/AD5449 Interface

A serial interface between the DAC and DSP SPORT is shown

in Figure 48. In this interface example, SPORT0 is used to

transfer data to the DAC shift register. Transmission is initiated

by writing a word to the Tx register after the SPORT has been

enabled. In a write sequence, data is clocked out on each rising

edge of the DSP’s serial clock and clocked into the DAC input

shift register on the falling edge of its SCLK. The update of the

DAC output takes place on the rising edge of the SYNC signal.

SCLK

SYNC

TFS

SDIN

ADSP-2101/

ADSP-2103/

ADSP-2191*

*ADDITIONAL PINS OMITTED FOR CLARITY

AD5429/AD5439/

AD5449*

Figure 48. ADSP-2101/ADSP-2103/ADSP-2191 SPORT to

AD5429/AD5439/AD5449 Interface

Communication between two devices at a given clock speed is

possible when the following specifications are compatible:

frame sync delay and frame sync setup-and-hold, data delay and

data setup-and-hold, and SCLK width. The DAC interface

expects a t4 SYNC falling edge to SCLK falling edge setup time)

of 13 ns minimum. See the ADSP-21xx User Manual for details

on clock and frame sync frequencies for the SPORT register.

Table 12 shows how the SPORT control register must be set up.

Table 12.

Name

Setting

Description

TFSW

Alternate framing

INVTFS

Active low frame signal

DTYPE

Right-justify data

ISCLK

Internal serial clock

TFSR

Frame every word

ITFS

Internal framing signal

SLEN

1111

16-bit data-word

80C51/80L51 to AD5429/AD5439/AD5449 Interface

A serial interface between the DAC and the 80C51/80L51 is

shown in Figure 49. TxD of the 80C51/80L51drives SCLK of the

DAC serial interface, while RxD drives the serial data line, DIN.

P1.1 is a bit-programmable pin on the serial port and is used to

drive SYNC. When data is to be transmitted to the switch, P1.1

is taken low. The 80C51/80L51 transmit data only in 8-bit bytes;

thus, only eight falling clock edges occur in the transmit cycle.

To load data correctly to the DAC, P1.1 is left low after the first

eight bits are transmitted, and a second write cycle is initiated to

transmit the second byte of data. Data on RXD is clocked out of

the microcontroller on the rising edge of TXD and is valid on

the falling edge. As a result, no glue logic is required between

the DAC and microcontroller interface. P1.1 is taken high

following the completion of this cycle. The 80C51/80L51

provide the LSB of the SBUF register as the first bit in the data

stream. The DAC input register requires its data with the MSB

as the first bit received. The transmit routine should take this

into account.

SCLK

TxD

80C51*

SYNC

P1.1

SDIN

RxD

*ADDITIONAL PINS OMITTED FOR CLARITY

AD5429/AD5439/

AD5449*

Figure 49. 80C51/80L51 to AD5429/AD5439/AD5449 Interface

AD5546 Arkusz danych(PDF) 22 Page - Analog Devices

AD5546 Arkusz danych(HTML) 22 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Arkusz danych Pobierz

Link URL