LM2502 datasheet(25/27 Pages) NSC

Numer części	LM2502

Szczegółowy opis	Mobile Pixel Link (MPL) Display Interface Serializer and Deserializer

PDF	27 Pages

Scroll/Zoom	100%

Producent	NSC [National Semiconductor (TI)]

Strona internetowa	http://www.national.com

Logo

25 / 27 page

Application Information (Continued)

Figure 21 shows the typical timing of the RGB application.

The 6X PLL setting (PLLCON[2:0] = 010’b) is selected. The

PCLK is applied to both the WR* and CLK inputs on the

Master. The rising edge on the WR* (PCLK) signal samples

the data by the Master for serialization. The CLK input can

be the PCLK (if timing requirements are met) or a synchro-

nous clock to the PCLK signal. The HS connects to the CS1*

signal and the HS* (inverted HS) is connected to the CS2*.

With this configuration there will always be a valid CS* LOW

on the Master input. The RGB information is then serialized

and passed to the Slave via the MPL bus. It takes 5 MC

cycles to complete the transfer and with the 6X PLL setting,

there will be two idle bits on the MD (1 MC cycle) lines before

the next transfer. Recovery of the RGB interface (RGB565,

HS, VS and PCLK) is provided at the Slave output. The

PCLK is slightly shifted later in time (1 MC cycle) but ad-

equate timing margin (increased set, shorted hold) is still

provided.

20093323

FIGURE 21. RGB565 Application Timing

LM2502 Arkusz danych(PDF) 25 Page - National Semiconductor (TI)