SCAS290 datasheet(6/53 Pages) TI

6 / 53 page

EVM Description and Basics

www.ti.com

Table 2. List of Jumpers and Switches (continued)

Default

Jumper

Position

Jumper Description

W15

Open

When installed, connects GPIO4 to reset AND gate (U3).

W16

Installed

Provides a means of measuring IOVDD current.

W17

Installed

Provides a means of measuring DVDD current.

W18

Installed

Provides a means of measuring LDOin/HPVDD current.

W19

Installed

Provides a means of measuring AVDD current.

W20

2-3

Sets U6 voltage source as +5VD or +5VA for LDOin/HPVDD.

W21

Installed

Connects +3.3VD voltage source to IOVDD node.

W22

Open

When installed, shorts across the input capacitor on IN2_L for DC measurement option. Remove this jumper for audio connections.

W23

Open

When installed, shorts across the input capacitor on IN2_R for DC measurement option. Remove this jumper for audio connections.

SW1

I2C

When set to I2C, the I2C signals from P12/J12 are connected to the codec and SPI_SELECT is set low. When set to SPI, the SPI

signals from P12/J12 are connected to the codec and SPI_SELECT is pulled to IOVDD.

SW2

LOW

When set to LOW, AVDD and DVDD are connected to +1.8VA and +1.8VD, respectively, and LDO_SELECT is set low. When set to

HI, AVDD, and DVDD are disconnected from other supplies and LDO_SELECT is pulled to IOVDD.

2.3

Analog Signal Connections

2.3.1

Analog Inputs

The analog input sources can be applied directly to terminal blocks J2, J3, and J4 or input jacks J1 and

J5. The connection details can be found in Appendix A.

2.3.2

Analog Output

The analog outputs are available from terminal blocks J6 and J8 or output jacks J7, J9, and J10. Note that

J10 is provided for signal-to-noise ratio (SNR) measurements only. The connection details can be found in

Appendix A.

2.4

Digital Signal Connections

The digital inputs and outputs of the EVM can be monitored through P12 and P22. If external signals need

to be connected to the EVM, digital inputs must be connected via J14 and J15 on the USB-MODEVM and

the SW2 switch must be changed accordingly (see Section 2.2.1). The connector details are available in

Section A.2.

2.5

Power Connections

The TLV320AIC3204EVM can be powered independently when being used in stand-alone operation or by

the USB-MODEVM when it is plugged onto the motherboard.

TLV320AIC3204EVM-K

SLAU266A – October 2008 – Revised October 2012

Submit Documentation Feedback

SCAS290 Arkusz danych(PDF) 6 Page - Texas Instruments

SCAS290 Arkusz danych(HTML) 6 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

Arkusz danych Pobierz

Link URL