MCP102 datasheet(13/24 Pages) MICROCHIP

13 / 24 page

 2004 Microchip Technology Inc.

DS-21906A-page 13

MCP102/103/121/131

4.2

Negative Going VDD Transients

The minimum pulse width (time) required to cause a

reset may be an important criteria in the implementa-

tion of a POR circuit. This time is referred to as

transient duration and is the amount of time needed for

these supervisory devices to respond to a drop in VDD.

The transient duration time is dependant on the magni-

tude of VTRIP – VDD. Generally speaking, the transient

duration decreases with increases in VTRIP – VDD.

Figure 4-3 shows a typical transient duration vs. reset

comparator overdrive, for which the MCP102/103/121/

131 will not generate a reset pulse. It shows that the

farther below the trip point the transient pulse goes, the

duration of the pulse required to cause a reset gets

shorter. Figure 2-32 shows the transient response

characteristics for the MCP102/103/121/131.

A 0.1 µF bypass capacitor, mounted as close as

possible to the VDD pin, provides additional transient

immunity (refer to Figure 4-1).

FIGURE 4-3:

Example of Typical

Transient Duration Waveform.

4.3

Reset Power-up Timer (tRPU)

Figure 4-4 illustrates the device current states. While

the system is powering down, the device has a low

current. This current is dependent on the device VDD

and trip point. When the device VDD rises through the

voltage trip point (VTRIP), an internal timer starts. This

timer consumes additional current until the RST pin is

driven (or released) high. This time is known as the

Reset Power-up Time (tRPU). Figure 4-4 shows when

tRPU is active (device consuming additional current).

FIGURE 4-4:

Reset Power-up Timer

Waveform.

4.3.1

EFFECT OF TEMPERATURE ON

RESET POWER-UP TIMER (TRPU)

The Reset Power-up timer time-out period (t

RPU)

determines how long the device remains in the reset

condition. This is affected by both V

DD and temperature.

Typical

responses

for

different

values

and

temperatures are shown in Figures 2-26, 2-27 and

2-28.

Time (µs)

VTRIP(MIN) - VDD

tTRANS

VTRIP(MAX)

VTRIP(MIN)

VTRIP

VDD

RST

tRPU

Reset Power-up

Timer Inactive

Reset

Power-up

Timer

Inactive

See Figures 2-1,

2-2 and 2-3

See Figures 2-4,

2-5 and 2-6

See Figures 2-1,

2-2 and 2-3

MCP102 Arkusz danych(PDF) 13 Page - Microchip Technology

MCP102 Arkusz danych(HTML) 13 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Arkusz danych Pobierz

Link URL