SIM800C datasheet(20/52 Pages) SIMCOM

20 / 52 page

Smart Machine Smart Decision

SIM800C_Hardware_Design_V1.02

2015-4-27

When power on procedure is completed, SIM800C will send following URC to indicate that the module is ready

to operate at fixed baud rate.

RDY

This URC does not appear when autobauding function is active.

Note: Customer can use AT command “AT+IPR=x” to set a fixed baud rate and save the configuration to

non-volatile flash memory. After the configuration is saved as fixed baud rate, the Code “RDY” should be

received from the serial port every time when SIM800C is powered on. For details, please refer to the chapter

“AT+IPR” in document [1].

4.2.2.

Power off SIM800C

SIM800C will be powered off in the following situations：



Normal power off procedure: power off SIM800C by the PWRKEY pin.



Normal power off procedure: power off SIM800C by AT command “AT+CPOWD=1”.



Abnormal power off: over-voltage or under-voltage automatic power off.



Abnormal power off: over-temperature or under-temperature automatic power off.

4.2.2.1.

Power off SIM800C by the PWRKEY Pin

Customer can power off SIM800C by pulling down the PWRKEY pin for at least 1 second and release. Please

refer to the power on circuit. The power off timing is illustrated in the following figure.

PW R K EY

VD D _EXT

ST AT U S

V IL<0.7V

Serialport

Undifined

Active

(input)

T 3=2s

1s<T 1<33s

T 2≥2s

Figure 13: Timing of power off SIM800C by PWRKEY

Note:

the module will restart after pull down the pwrkey over 33 seconds.

VDD_EXT will power off after STATUS change into low level and the PWRKEY release 55ms..

If 1s<T1<2s，T2>2s；

If 2s≤T1<33s，T2>T1+55ms

This procedure makes the module log off from the network and allows the software to enter into a secure state to

save data before completely shut down.

Before the completion of the power off procedure, the module will send URC:

NORMAL POWER OFF

At this moment, AT commands can not be executed any more. Power off mode can also be indicated by STATUS

pin, which is at low level at this time.

4.2.2.2.

Power off SIM800C by AT Command

SIM800C Arkusz danych(PDF) 20 Page - SIMCom

SIM800C Arkusz danych(HTML) 20 Page - SIMCom

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Arkusz danych Pobierz

Link URL