TDA8752 datasheet(18/36 Pages) PHILIPS

18 / 36 page

1999 Mar 09

Philips Semiconductors

Product speciﬁcation

Triple high speed Analog-to-Digital

Converter (ADC)

TDA8752

OFFSET REGISTER

This register controls the clamp level for the RGB

channels. The relationship between the programming

code and the level of the clamp code is given in Table 2.

Table 2

Coding

The default programmed value is:

• Programmed code = 127

• Clamp code = 0

• ADC output = 0.

COARSE AND FINE REGISTERS

These two registers enable the gain control, the AGC gain

with the coarse register and the reference voltage with the

fine register. The coarse register programming equation is

as follows:

Where: Vref = 2.5 V.

The gain correspondence is given in Table 3. The gain is

linear with reference to the programming code (NFINE = 0).

PROGRAMMED

CODE

CLAMP CODE

ADC OUTPUT

−63.5

underﬂow

−63

−62.5

↓↓

127

↓↓↓

254

63.5

63 or 64

255

GAIN

COARSE

ref 1

FINE

-------------------

–





----------------------------------------------

------

COARSE

ref 512

FINE

–

()

-------------------------------------------------

Table 3

Gain correspondence (COARSE)

The default programmed value is as follows:

• N

COARSE =32

• Gain = 0.825

• Vi to be full-scale = 1.212.

To modulate this gain, the fine register is programmed

using the above equation. With a full-scale ADC input, the

fine register resolution is a 1

⁄2LSB peak-to-peak

(see Table 4 for NCOARSE = 32).

Table 4

Gain correspondence (FINE)

The default programmed value is: NFINE =0.

CONTROL REGISTER

COAST and HSYNC signals can be inverted by setting the

I2C-bus control bits V level and H level respectively. When

V level and H level are set to zero respectively, COAST

and HSYNC are active HIGH.

The bit ‘edge’ defines the rising or falling edge of CKREF

to synchronise the PLL. It will be on the rising edge if the

bit is at logic 0 and on the falling edge if the bit is at logic 1.

The bits Up and Do are used for the test, to force the

charge pump current. These bits have to be logic 0 during

normal use.

The bits Ip0, Ip1 and Ip2 control the charge pump current,

to increase the bandwidth of the PLL, as shown in Table 5.

NCOARSE

GAIN

Vi TO BE

FULL-SCALE

0.825

1.212

2.5

0.4

NFINE

GAIN

Vi TO BE

FULL-SCALE

0.825

1.212

0.878

1.139

TDA8752 Arkusz danych(PDF) 18 Page - NXP Semiconductors

TDA8752 Arkusz danych(HTML) 18 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Arkusz danych Pobierz

Link URL