This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

15

EN25F80

Rev. D, Issue Date: 2007/05/16

The instruction sequence is shown in Figure 11. If more than 256 bytes are sent to the device, previously

latched data are discarded and the last 256 data bytes are guaranteed to be programmed correctly within

the same page. If less than 256 Data bytes are sent to device, they are correctly programmed at the

requested addresses without having any effects on the other bytes of the same page.

Chip Select (CS#) must be driven High after the eighth bit of the last data byte has been latched in,

otherwise the Page Program (PP) instruction is not executed.

initiated. While the Page Program cycle is in progress, the Status Register may be read to check the value

of the Write In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed Page

Program cycle, and is 0 when it is completed. At some unspecified time before the cycle is completed, the

Write Enable Latch (WEL) bit is reset.

A Page Program (PP) instruction applied to a page which is protected by the Block Protect (BP2, BP1,

BP0) bits (see Table 3) is not executed.

Sector Erase (SE) (20h)

The Sector Erase (SE) instruction sets to 1 (FFh) all bits inside the chosen sector. Before it can be

accepted, a Write Enable (WREN) instruction must previously have been executed. After the Write Enable

(WREN) instruction has been decoded, the device sets the Write Enable Latch (WEL).

The Sector Erase (SE) instruction is entered by driving Chip Select (CS#) Low, followed by the instruction

code, and three address bytes on Serial Data Input (DI). Any address inside the Sector (see Table 2) is a

valid address for the Sector Erase (SE) instruction. Chip Select (CS#) must be driven Low for the entire

duration of the sequence.

The instruction sequence is shown in Figure 12.. Chip Select (CS#) must be driven High after the eighth

bit of the last address byte has been latched in, otherwise the Sector Erase (SE) instruction is not

executed. As soon as Chip Select (CS#) is driven High, the self-timed Sector Erase cycle (whose duration