TS5V522C

www.ti.com

SCDS317

– MARCH 2011

PARAMETER DEFINITIONS

PARAMETER

DESCRIPTION

rON

Resistance between the input and output ports with the switch in the ON-state

IOZ

Output leakage current measured at the D and S ports with the switch in the OFF-state

IOS

Short circuit current measured at the I/O pins.

VIN

Voltage at the IN pin

VEN

Voltage at the EN pin

CIN

Capacitance at the control inputs (EN, IN)

COFF

Capacitance at the analog I/O port when the switch is OFF

CON

Capacitance at the analog I/O port when the switch is ON

VIH

Minimum input voltage for logic high for the control inputs (EN, IN)

VIL

Minimum input voltage for logic low for the control inputs (EN, IN)

VH

Hysteresis voltage at the control inputs (EN, IN)

VIK

I/O and control inputs diode clamp voltage (EN, IN)

VI

Voltage applied to the I/O pins when I/O is the switch input.

VO

Voltage applied to the I/O pins when I/O is the switch output.

IIH

Input high leakage current of the control inputs (EN, IN)

IIL

Input low leakage current of the control inputs (EN, IN)

II

Current into the I/O pins when I/O is the switch input.

IO

Current into the I/O pins when I/O is the switch output.

Ioff

Output leakage current measured at the I/O ports with VCC = 0

Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned

tON

ON.

Propagation delay measured between 50% of the digital input to 90% of the analog output when switch is turned

tOFF

OFF.

BW

Frequency response of the switch in the ON-state measured at

–3 dB

Unwanted signal coupled from channel to channel. Measured in

–dB. XTALK = 20 LOG VOUT/VIN. This is a

XTALK

non-adjacent crosstalk.

OIRR

Off-isolation is the resistance (measured in

–dB) between the input and output with the switch OFF.

Magnitude variation between analog input and output pins when the switch is ON and the DC offset of composite

DG

video signal varies at the analog input pin. In NTSC standard the frequency of the video signal is 3.58 MHz and

DC offset is from 0 to 0.714 V.

Phase variation between analog input and output pins when the switch is ON and the DC offset of composite

DP

video signal varies at the analog input pin. In NTSC standard the frequency of the video signal is 3.58 MHz and

DC offset is from 0 to 0.714 V.

ICC

Static power supply current

ICCD

Variation of ICC for a change in frequency in the control inputs (EN, IN)

This is the increase in supply current for each control input that is at the specified voltage level, rather than VCC or

ΔICC

GND.

Copyright

© 2011, Texas Instruments Incorporated

Submit Documentation Feedback

3

Product Folder Link(s) :TS5V522C