US2884 datasheet(8/11 Pages) MELEXIS

8 / 11 page

US2884

Bipolar Hall Switch – Very High Sensitivity

3901002884

Page 8 of 11

Data Sheet

Rev 004

Jan/06

13 Application Information

14 Application Comments

For proper operation, a 100nF bypass capacitor should be placed as close as possible to the device between

the VDD and ground pin.

For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the VDD pin.

When using a resistor, three points are important:

- the resistor has to limit the reverse current to 50mA maximum (VCC / R1 ≤ 50mA)

- the resulting device supply voltage VDD has to be higher than VDD min (VDD = VCC – R1.IDD)

- the resistor has to withstand the power dissipated in reverse voltage condition (PD = VCC

2 / R1)

When using a diode, a reverse current cannot flow and the voltage drop is almost constant (≈0.7V).

Therefore, a 100Ω/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.

Both solutions provide the required reverse voltage protection.

When a weak power supply is used or when the device is intended to be used in noisy environment, it is

recommended that figure 13.3 from the Application Information section is used.

The low-pass filter formed by R1 and C1 and the zener diode Z1 bypass the disturbances or voltage spikes

occurring on the device supply voltage VDD. The diode D1 provides additional reverse voltage protection.

13.1 Typical Three-Wire Application Circuit

13.3 Automotive and Harsh, Noisy Environments

Three-Wire Circuit

13.2 Two-Wire Circuit

Note:

With this circuit, precise ON and OFF

currents can be detected using only

two connecting wires.

The resistors RL and Rb can be used

to bias the input current. Refer to the

part specifications for limiting values.

BRP :

IOFF = IR + IDD = VDD/Rb + IDD

BOP :

ION = IOFF + IOUT = IOFF + VDD/RL

US2884 Arkusz danych(PDF) 8 Page - Melexis Microelectronic Systems