2

INTRODUCTION

Thank you for purchasing this CLARKE Submersible Water Pump. CSE pumps

are designed for pumping clean water only and will pump down to a water

level of 20mm.

This pump is designed for pumping clean water or water containing solids in

suspension and is ideally suited for draining ponds, pools, sumps etc. It is not

designed for pumping slurry, sludge, mud or heavily polluted water, or any

water containing chemicals or other acidic contaminants including salt water.

Pumps fitted with float switches are suitable for permanent or semi-permanent

installations where it is necessary to maintain water at a particular level.

As the water level rises, the float switch will rise and start the pump. As the

water level falls, so will the float switch until it stops the pump. Float switches

are factory set to provide the correct on/off switching mode, however, you

can adjust the level at which the pump cuts out by sliding the float switch

cable in its clip attached to the handle, to either shorten or lengthen as

required. The shorter the cable, the earlier it will cut out and therefore, the

deeper the water will remain at this point.

PUMP SPECIFICATION

CSE2

CSD3

CSV1A

CSV2A

Dimensions excluding

the elbow

140 x

302mm

149 x

400mm

143 x

300mm

143 x

335mm

Weight

4.3kg

8.0 kg

4.6 kg

5.6 kg

Cable Size

10 x 0.75

(m x mm2)

15 x 1.0 (m

x mm2)

10 x 0.75

(m x mm2)

10 x 0.75

(m x mm2)

Max. Capacity

253 L/min

95 L/min

118 L/min

236 L/min

Head Max

10 m

45 m

5 m

9 m

Motor Output

750 W

900 W

330 W

650 W

Outlet Diameter

1

¼”/

32mm

1”/ 25mm

1

¼”/

32mm

1

¼”/

32mm

S