TC510CPF datasheet(9/17 Pages) TELCOM

9 / 17 page

3-27

TELCOM SEMICONDUCTOR, INC.

Figure 5. Comparator Output

INTEGRATOR

OUTPUT

ZERO

CROSSING

COMPARATOR

OUTPUT

REFERENCE

DEINTEGRATE

SIGNAL

INTEGRATE

INTEGRATOR

OUTPUT

ZERO

CROSSING

COMPARATOR

OUTPUT

REFERENCE

DEINTEGRATE

SIGNAL

INTEGRATE

B. Negative Input Signal

A. Positive Input Signal

Comparator Output

By monitoring the comparator output during the fixed

signal integrate time, the input signal polarity can be deter-

mined by the microprocessor controlling the conversion.

The comparator output is HIGH for positive signals and LOW

for negative signals during the signal-integrate phase (see

timing diagram).

During the reference deintegrate phase, the comparator

output will make a HIGH-to-LOW transition as the integrator

output ramp crosses zero. The transition is used to signal the

processor that the conversion is complete.

The internal comparator delay is 2

µsec, typically. Figure

5 shows the comparator output for large positive and nega-

tive signal inputs. For signal inputs at or near zero volts,

however, the integrator swing is very small. If common-

mode noise is present, the comparator can switch several

times during the beginning of the signal-integrate period. To

ensure that the polarity reading is correct, the comparator

output should be read and stored at the end of the signal

integrate phase.

The comparator output is undefined during the Auto-

Zero Phase and is used to time the Integrator Output Zero

phase. (See

Integrator Output Zero Phase of System Timing

section).

PRECISION ANALOG FRONT ENDS

TC500

TC500A

TC510

TC514

TC510CPF Arkusz danych(PDF) 9 Page - TelCom Semiconductor, Inc

TC510CPF Arkusz danych(HTML) 9 Page - TelCom Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Arkusz danych Pobierz

Link URL