UM0034 datasheet(7/39 Pages) STMICROELECTRONICS

7 / 39 page

ST7-EMU3 series emulator

Getting Started with ST7-EMU3

7/39

2.2

Quick set up for emulation configuration

Connect your PC to your ST Micro Connect box via parallel, USB or Ethernet port. For

more details refer toChapter 3: Connectivity on page 9.

For Ethernet connections, you must assign your ST Micro Connect box an IP address.

For instructions refer to Section 3.3: Ethernet connection on page 12.

Caution:

Before connecting your emulator and your application board, make sure that both your ST

Micro Connect box and the application board are powered OFF.

Fasten ferrite clips to the 80-wire flat cables connecting the ST Micro Connect box to

your EMU3 probe (see Figure 4).

Connect your application board to the EMU3-probe. You can use the emulator without

connecting to your application board. For details about connecting to your application

board refer to your ST7xxxx-EMU3 Probe User Guide provided with your emulator.

Caution:

Never have your application board powered on while the emulator is powered off—this can

cause serious damage to the emulator.

Connect the power supply to your ST Micro Connect box. For power supply

information, refer to Section 4.3.3: Power supply on page 19.

Power up your ST Micro Connect box.

Power up your application.

Caution:

You must always power up your emulator and your application board before running your

application executable in STVD7. Doing otherwise will result in an erroneous emulation.

Figure 3.

Connect your PC

Figure 4.

Fasten the ferrite clips

ST Micro Connect box

(back panel)

Parallel

Ethernet

USB

EMU3 probe

ST Micro Connect box

UM0034 Arkusz danych(PDF) 7 Page - STMicroelectronics