56F8366 datasheet(2/182 Pages) FREESCALE

2 / 182 page

56F8366 Technical Data, Rev. 7

Freescale Semiconductor

Preliminary

Document Revision History

Version History

Description of Change

Rev 0

Pre-release, Alpha customers only

Rev 1.0

Initial Public Release

Rev 2.0

Added output voltage maximum value and note to clarify in Table 10-1; also removed overall

life expectancy note, since life expectancy is dependent on customer usage and must be

determined by reliability engineering. Clarified value and unit measure for Maximum allowed

PD in Table 10-3. Corrected note about average value for Flash Data Retention in Table 10-4.

Added new RoHS-compliant orderable part numbers in Table 13-1.

Rev 3.0

Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient

Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in Table 10-4.

Added RoHS-compliance and “pb-free” language to back cover

Rev 4.0

Added information/corrected state during reset in Table 2-2. Clarified external reference

crystal frequency for PLL in Table 10-14 by increasing maximum value to 8.4MHz.

Rev 5.0

Replaced “Tri-stated” with an explanation in State During Reset column in Table 2-2.

Rev. 6

• Added the following note to the description of the TMS signal in Table 2-2:

Note:

Always tie the TMS pin to VDD through a 2.2K resistor.

• Added the following note to the description of the TRST signal in Table 2-2:

Note:

For normal operation, connect TRST directly to VSS. If the design is to be used in a debugging

environment, TRST may be tied to VSS through a 1K resistor.

Rev. 7

• Remove pullup comment from PWM pins in Table 2-2.

•Add Figure 10-1 showing current voltage characteristics.

•In Table 10-24, correct interpretation of Calibration Factors to be viewed as worst case

factors.

Please see http://www.freescale.com for the most current data sheet revision.

56F8366 Arkusz danych(PDF) 2 Page - Freescale Semiconductor, Inc