AS1330 datasheet(2/16 Pages) AMSCO

2 / 16 page

www.austriamicrosystems.com/DC-DC_Step-Up/AS1330

Revision 1.04

2 - 16

AS1330

Datasheet - P i n A s s i g n m e n t s

4 Pin Assignments

Figure 2. Pin Assignments (Top View)

Pin Descriptions

Table 1. Pin Descriptions

Pin Number

Pin Name

Description

SENSE

Sense Input. Represents the input for the Power-OK behaviour. This input can be

used to supervise the input or the output voltage via a resistor divider. If connected

to GND the POK output is related to VOUT.

Feedback Pin. Feedback input to the gm error amplifier. Connect a resistor divider

tap to this pin. The output voltage can be adjusted from 1.8 to 3.3V by: VOUT =

0.8V[1 + (R1/R2)]

If the fixed output voltage version ist used, connect this pin to VOUT.

Active-High Enable Input. A logic LOW reduces the supply current to < 1µA.

Connect to pin VIN for normal operation.

POK

Power-OK Output. Active-High, open-drain output indicates an out-of-regulation

condition. Connect a 100k

Ω pull-up resistor to pin OUT for logic levels. Leave this

pin unconnected if the Power-OK feature is not used.

Low Level:

High Level:

GND

Signal and Power Ground. Provide a short, direct PCB path between this pin and

the negative side of the output capacitor(s).

Switch Pin. Connect an inductor between this pin and VIN. Keep the PCB trace

lengths as short and wide as is practical to reduce EMI and voltage overshoot. If

the inductor current falls to zero, or pin EN is low, an internal 100

Ω anti-ringing

switch is connected from this pin to VIN to minimize EMI.

Note: An optional Schottky diode can be connected between this pin and VOUT.

VOUT

Output Voltage. Bias is derived from VOUT when VOUT exceeds VIN. PCB trace

length from VOUT to the output filter capacitor(s) should be as short and wide as is

practical.

8VIN

Input Voltage. The AS1330 gets its start-up bias from VIN unless VOUT exceeds

VIN, in which case the bias is derived from VOUT. Thus, once started, operation is

completely independent from VIN. Operation is only limited by the output power

level and the internal series resistance of the supply.

Exposed Pad. The exposed pad must be connected to GND. Ensure a good

connection to the PCB to achieve optimal thermal performance.

SENSE

AS1330

POK

8 VIN

7 VOUT

5 GND

6 SW

AS1330 Arkusz danych(PDF) 2 Page - ams AG

AS1330 Arkusz danych(HTML) 2 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Arkusz danych Pobierz

Link URL