MCP4361104ESLASHST datasheet(6/80 Pages) MICROCHIP

6 / 80 page

MCP434X/436X

DS22233A-page 6

Resistor Terminal

Input Voltage

Range (Terminals

A, B and W)

VA,VW,VB

Vss

—

VDD

Note 5, Note 6

Maximum current

through A, W or B

——

2.5

Note 6, Worst case current through

wiper when wiper is either Full Scale or

Zero Scale.

Leakage current

into A, W or B

IWL

—100

—

MCP43X1 PxA = PxW = PxB = VSS

—100

—

MCP43X2 PxB = PxW = VSS

AC/DC CHARACTERISTICS (CONTINUED)

DC Characteristics

Standard Operating Conditions (unless otherwise specified)

Operating Temperature

–40°C

≤ T

A ≤ +125°C (extended)

All parameters apply across the specified operating ranges unless noted.

VDD = +2.7V to 5.5V, 5 kΩ, 10 kΩ, 50 kΩ, 100 kΩ devices.

Typical specifications represent values for VDD = 5.5V, TA = +25°C.

Parameters

Sym

Min

Typ

Max

Units

Conditions

Note 1:

Resistance is defined as the resistance between terminal A to terminal B.

INL and DNL are measured at VW with VA = VDD and VB = VSS.

MCP43X1 only.

MCP43X2 only, includes VWZSE and VWFSE.

Resistor terminals A, W and B’s polarity with respect to each other is not restricted.

This specification by design.

Non-linearity is affected by wiper resistance (RW), which changes significantly over voltage and

temperature.

The MCP43X1 is externally connected to match the configurations of the MCP43X2, and then tested.

POR/BOR is not rate dependent.

10: Supply current is independent of current through the resistor network.

MCP4361104E/ST Arkusz danych(PDF) 6 Page - Microchip Technology

MCP4361104E/ST Arkusz danych(HTML) 6 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

Arkusz danych Pobierz

Link URL