MP4560 – 2A, 2MHz, 55V STEP-DOWN CONVERTER

MP4560 Rev. 1.0

www.MonolithicPower.com

4

11/5/2012

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2012 MPS. All Rights Reserved.

PIN FUNCTIONS

QFN

Pin #

SOIC8

Pin #

Name

Description

1, 2

1

SW

to ground is required. The rectifier must be close to the SW pins to reduce switching

spikes.

3

2

EN

Enable Input. Pulling this pin below the specified threshold shuts the chip down.

Pulling it up above the specified threshold or leaving it floating enables the chip.

4

3

COMP

Compensation. This node is the output of the GM error amplifier. Control loop

frequency compensation is applied to this pin.

5

4

FB

Feedback. This is the input to the error amplifier. An external resistive divider

connected between the output and GND is compared to the internal +0.8V reference

to set the regulation voltage.

6

5

GND,

Exposed

pad

Ground. It should be connected as close as possible to the output capacitor avoiding

the high current switch paths. Connect exposed pad to GND plane for optimal thermal

performance.

7

6

FREQ

Switching Frequency Program Input. Connect a resistor from this pin to ground to set

the switching frequency.

8, 9

7

VIN

Input Supply. This supplies power to all the internal control circuitry, both BS

regulators and the high-side switch. A decoupling capacitor to ground must be placed

close to this pin to minimize switching spikes.

10

8

BST

Bootstrap. This is the positive power supply for the internal floating high-side

MOSFET driver. Connect a bypass capacitor between this pin and SW pin.