AM29F100 datasheet(18/36 Pages) AMD

18 / 36 page

Am29F100

than 50

µs. See also the “Sector Erase Command Se-

quence” section.

After the sector erase command sequence is written,

the system should read the status on DQ7 (Data# Poll-

ing) or DQ6 (Toggle Bit I) to ensure the device has ac-

cepted the command sequence, and then read DQ3. If

DQ3 is “1”, the internally controlled erase cycle has be-

gun; all further commands (other than Erase Suspend)

are ignored until the erase operation is complete. If

DQ3 is “0”, the device will accept additional sector

erase commands. To ensure the command has been

accepted, the system software should check the status

of DQ3 prior to and following each subsequent sector

erase command. If DQ3 is high on the second status

check, the last command might not have been ac-

cepted. Table 6 shows the outputs for DQ3.

START

Yes

DQ5 = 1?

Yes

Toggle Bit

= Toggle?

Program/Erase

Operation Not

Complete, Write

Reset Command

Program/Erase

Operation Complete

Read DQ7–DQ0

Toggle Bit

= Toggle?

Read DQ7–DQ0

Twice

Read DQ7–DQ0

Notes:

1. Read toggle bit twice to determine whether or not it is

toggling. See text.

2. Recheck toggle bit because it may stop toggling as DQ5

changes to “1”. See text.

18926C-10

Figure 5.

Toggle Bit Algorithm

(Notes

1, 2)

AM29F100 Arkusz danych(PDF) 18 Page - Advanced Micro Devices

AM29F100 Arkusz danych(HTML) 18 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Arkusz danych Pobierz

Link URL