AM79C971VCW datasheet(85/265 Pages) AMD

85 / 265 page

Am79C971

Figure 42.

SRAM and Flash Configuration for the Expansion Bus

The time that the Am79C971 controller waits for data to

be valid is programmable. ROMTMG (BCR18, bits 15-

12) defines the time from when the Am79C971 control-

ler drives EBUA_EBA[7:0] with the lower 8 bits of the

Expansion ROM address to when the Am79C971 con-

troller latches in the data on the EBD[7:0] inputs. The

cles. When ROMTMG is set to nine (the default value),

EBD[7:0] is sampled with the next rising edge of CLK

ten clock cycles after EBUA_EBA[7:0] was driven with

a new address value. The clock edge that is used to

sample the data is also the clock edge that generates

the next Expansion ROM address. All four bytes of Ex-

pansion ROM data are stored in holding registers. One

clock cycle after the last data byte is available, the

Am79C971 controller asserts TRDY.

The access time for the Expansion ROM device (tACC)

can be calculated by subtracting the clock-to-output

delay for the EBUA_EBA[7:0] outputs (tv_A_D) and the

input-to-clock setup time for the EBD[7:0] inputs (ts_D)

from the time defined by ROMTMG:

tACC <= ROMTMG* clock period - tv_A_D - ts_D

For an adapter card application, the value used for

clock period should be 30 ns to guarantee correct inter-

face timing at the maximum clock frequency of 33 MHz.

The timing diagram in Figure 45 assumes the default

programming of ROMTMG (1001b = 9 CLK). After

reading the first byte, the Am79C971 controller reads in

three more bytes by incrementing the lower portion of

the ROM address. After the last byte is strobed in,

TRDY will be asserted on clock 50. When the host tries

to perform a burst read of the Expansion ROM, the

Am79C971 controller will disconnect the access at the

second data phase.

The host must program the Expansion ROM Base Ad-

dress register in the PCI configuration space before the

first access to the Expansion ROM. The Am79C971

controller will not react to any access to the Expansion

ROM until both MEMEN (PCI Command register, bit 1)

and ROMEN (PCI Expansion ROM Base Address reg-

ister, bit 0) are set to 1.

EBUA_EBA[7:0]

EBDA[15:8]

EBD[7:0]

I/O[7:0]

A[7:0]

A[14:8]

I/O[7:0]

A[7:0]

A[14:8]

EBWE

ERAMCS

AS_/EBOE

A[15:8]

A[7:0]

DQ[7:0]

Am79C971

'374

D-FF

32K x 8 SRAM

FLASH

32K x 8 SRAM

EROMCS

A[23:16]

20550D-45

AM79C971VCW Arkusz danych(PDF) 85 Page - Advanced Micro Devices

AM79C971VCW Arkusz danych(HTML) 85 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Arkusz danych Pobierz

Link URL