CS5321 datasheet(32/38 Pages) CIRRUS

32 / 38 page

CS5320/21/22

DS454PP1

SOD - Serial Output Data, Pin 24

The output coding is 2’s complement with the data bits presented MSB first, LSB last. Data

changes on the rising edge of SCLK. An internal nominal 100 k

Ω pull-up resistor is included.

Digital Inputs

MDATA – Modulator Data, Pin 10

Data will be presented in a one-bit serial data stream at a bit rate of 256 KHz; (CLKIN =

1.024 MHz).

TDATA - Test Data, Pin 11

Input for user test data.

MFLG – Modulator Flag, Pin 6

A transition from a low to high level signals that the CS5320/21 modulator is unstable due to

an over-range on the analog input. A Status Bit will be set in the digital filter indicating an

error condition. An internal nominal 100 k

Ω pull-down resistor included on the input pin.

RESET - Filter Reset, Pin 4

Performs a hard reset on the chip, all registers and accumulators are cleared. All signals to the

device are locked out except CLKIN. The error flags in the Status Register are set to zero and

the Data Register and Offset Register are set to zero. The configuration register is set to the

values of the corresponding input pins. SYNC must be applied to resume convolutions after

RESET deasserts.

CLKIN - Clock Input, Pin 3

A CMOS-Compatible clock input to this pin (nominally 1.024 MHz) provides the necessary

clock for operation the modulator and filter.

SYNC - Frame Sync, Pin 2

Conversion synchronization input. This signal synchronizes the start of the filter convolution.

More than one SYNC signal can occur with no effect on filter performance, providing the

SYNC signals are perfectly timed at intervals equal to the output sample period.

CSEL - Channel Select, Pin 12

When high, information on the TDATA pin is presented to the digital filter. A low causes data

on the MDATA input to be presented to the digital filter.

PWDN - Powerdown, Pin 14

Powers down the filter when taken high. Convolution cycles in the digital filter and the MCLK

signal are stopped. The registers maintain their data and the serial port remains active. SYNC

must be applied to resume convolutions after PWDN deasserts.

DECA - Decimation Rate Control, Pin 18

See Table 4.

DECB - Decimation Rate Control, Pin 17

See Table 4.

CS5321 Arkusz danych(PDF) 32 Page - Cirrus Logic