SL1461MPAS datasheet(5/12 Pages) MITEL

5 / 12 page

SL1461SA

DESIGN OF PLL LOOP PARAMETERS

Fig.4

VCO

BASEBAND OUTPUT

RF INPUT

GAIN = K0 RAD SEC/VOLT

GAIN = KD VOLT/RAD

The SL1461SA is normally used as a type 1 second order

loop and can be represented by the above diagram. For such

a system the following parameters apply;

0KD

and

where:

K0 is the VCO gain in radian seconds per volt

KD is the phase detector gain in volts per radian

n is the natural loop bandwidth

is the loop damping factor

R1 is loop amplifier input impedance

Note:

K0 is dependant on sensitivity of VCO used.

KD = 0.25V/rad single ended, 0.5V/rad differential

From these factors the loop 3dB bandwidth can be determined

from the following expression;

AFC FACILITY

The SL1461SA contains an analog frequency error detect

circuit, which generates DC voltage proportional to the integral

of frequency error. If the incident RF is high then the AFC

voltage increases, if low then the voltage decreases. The AFC

voltage can then be converted by an ADC to be read by the

micro controller for frequency fine tuning; if used in an I2C

system it is recommended the device is used with either the

SP5055 or SP5056 frequency synthesiser which contains an

internal ADC readable via the I2C bus.

The voltage corresponding to frequency alignment is

arbitrary and user defined; if used with the SP5055 it is

suggested the aligned voltage is 0.375 VCC , corresponding to

the centre code of the ADC on port 6.

The AFC detect circuit contains a deadband centre

around the aligned frequency. The deadband can be adjusted

from zero window to approximately 25MHz width assuming an

oscillator dF/dV of 15MHz/V. If the incident RF is within this

window the AFC voltage does not integrate, except by

component leakage.

With reference to Fig.5; in normal operation the

demodulated video is fed to a dual comparator where it is

compared with two reference voltages, corresponding to the

extremes of the deadband, or window. These voltages are

variable and set by the window adjust input.

The comparators produce two digital outputs

corresponding to voltages above or below the voltage window,

or frequency above or below deadband. These digital control

signals are used to control a complimentary current source

pump. The current signals are then fed to the input of an

amplifier which is arranged as an integrator, so integrating the

pulses into a DC voltage.

If the frequency is correctly aligned both the current

source and sink are disabled, therefore the DC output voltage

remains constant. There will be a small drift due to component

leakage; the maximum drift can be calculated from;

SL1461MPAS Arkusz danych(PDF) 5 Page - Mitel Networks Corporation

SL1461MPAS Arkusz danych(HTML) 5 Page - Mitel Networks Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Arkusz danych Pobierz

Link URL