LM1882-R datasheet(11/16 Pages) NSC

11 / 16 page

Capacitance (Continued)

Additional Applications Information

POWERING UP

The ’ACT715/LM1882 default value for Bit 10 of the Status

plied and the registers are initialized by loading the default

values the CLOCK is disabled. Before operation can begin,

Bit 10 must be changed toa1to enable CLOCK. If the de-

fault values are needed (no other programming is required)

then

Figure 6 illustrates a hardwired solution to facilitate the

enabling of the CLOCK after power-up. Should control sig-

nals be difficult to obtain,

Figure 7 illustrates a possible solu-

tion to automatically enable the CLOCK upon power-up. Use

of the ’ACT715-R/LM1882-R eliminates the need for most of

this circuitry. Modifications of the

Figure 7 circuit can be

made to obtain the lone CLEAR pulse still needed upon

power-up.

Note that, although during a Vectored Restart none of the

preprogrammed registers are affected, some signals are af-

fected for the duration of one frame only. These signals are

the Horizontal and Vertical Drive signals. After a Vectored

Restart the beginning of these signals will occur at the first

CLK. The end of the signals will occur as programmed. At

the completion of the first frame, the signals will resume to

their programmed start and end time.

PREPROGRAMMING “ON-THE-FLY”

Although the ’ACT715/LM1882 and ’ACT715-R/LM1882-R

are completely programmable, certain limitations must be

set as to when and how the parts can be reprogrammed.

Care must be taken when reprogramming any End Time reg-

isters to a new value that is lower than the current value.

Should the reprogramming occur when the counters are at a

count after the new value but before the old value, then the

counters will continue to count up to 4096 before rolling over.

For this reason one of the following two precautions are rec-

ommended when reprogramming “on-the-fly”. The first rec-

ommendation is to reprogram horizontal values during the

horizontal blank interval only and/or vertical values during

the vertical blank interval only. Since this would require deli-

cate timing requirements the second recommendation may

be more appropriate.

The second recommendation is to program a Vectored Re-

start as the final step of reprogramming. This will ensure that

all registers are set to the newly programmed values and

that all counters restart at the first CLK position. This will

avoid overrunning the counter end times and will maintain

the video integrity.

DS100232-6

FIGURE 5. AC Specifications

LM1882-R Arkusz danych(PDF) 11 Page - National Semiconductor (TI)

LM1882-R Arkusz danych(HTML) 11 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Arkusz danych Pobierz

Link URL