LPS25H datasheet(27/45 Pages) STMICROELECTRONICS

27 / 45 page

DocID023722 Rev 5

27/45

LPS25H

7.7

CTRL_REG2

Control register 2

Address:

21h (R/W)

Reset:

00h

Description:

Control register.

Description:

BOOT bit is used to refresh the content of the internal registers stored in the Flash memory

block. At the device power-up the content of the Flash memory block is transferred to the

internal registers related to trimming functions to permit a good behavior of the device itself.

If for any reason, the content of the trimming registers is modified, it is sufficient to use this

bit to restore the correct values. When BOOT bit is set to ‘1’ the content of the internal Flash

is copied inside the corresponding internal registers and is used to calibrate the device.

These values are factory trimmed and they are different for every device. They permit good

behavior of the device and normally they should not be changed. At the end of the boot

process the BOOT bit is set again to ‘0’ by hardware. BOOT bit takes effect after one ODR

clock cycle.

SWRESET is the software reset bit. The device is reset to the power on configuration if the

SWRESET bit is set to ‘1’ and BOOT is set to ‘1’.

AUTO_ZERO, when set to ‘1’, the actual pressure output is copied in the REF_P_H &

REF_P_L & REF_P_XL and kept as reference and the PRESS_OUT_H & PRESS_OUT_L

& PRESS _OUT_XL is the difference between this reference and the pressure sensor

value.

210

BOOT

FIFO_EN

WTM_EN FIFO_MEAN_DEC

SWRESET

AUTO_ZERO ONE_SHOT

[7] BOOT: Reboot memory content. Default value: 0

(0: normal mode; 1: reboot memory content) Self-clearing upon completion)

[6] FIFO_EN: FIFO Enable. Default value: 0

(0: disable; 1: enable)

[5] WTM_EN: Enable FIFO Watermark level use. Default value 0

(0: disable; 1: enable)

[4] FIFO_MEAN_DEC: Enable 1Hz ODR decimation

(0: disable; 1 enable)

[3] I²C enable

(0: I2C enable;1: SPI disable)

[2] Software reset. Default value: 0

(0: normal mode; 1: software reset) Self-clearing upon completion)

[1] Autozero enable. Default value: 0

(0: normal mode; 1: autozero enable)

[0] One shot enable. Default value: 0

(0: waiting for start of conversion; 1: start for a new dataset)

LPS25H Arkusz danych(PDF) 27 Page - STMicroelectronics

LPS25H Arkusz danych(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Arkusz danych Pobierz

Link URL