STUSB1602 datasheet(21/55 Pages) STMICROELECTRONICS

21 / 55 page

DocID028319 Rev 2

21/55

STUSB1602

Features description

The I2C register bits mentioned above in quotes give either the state of the hardware fault

when it occurs or the setting condition to detect the hardware fault.

3.9

Accessory mode detection

The STUSB1602 supports the detection of audio accessory mode and debug accessory

mode as defined in the USB Type-C standard specification with the following Type-C power

modes (see Section 6: Start-up configuration):

•

Source power role with accessory support

•

Sink power role with accessory support

•

Dual power role with accessory support

•

Dual power role with accessory and Try.SRC support

•

Dual power role with accessory and Try.SNK support.

3.9.1

Audio accessory mode detection

The STUSB1602 detects an audio accessory device when both the CC1 and CC2 pins are

pulled down to ground by an Ra resistor from the connected device. The audio accessory

detection is advertised through the CC_ATTACHED_MODE bits of the I2C register

CC_CONNECTION_STATUS.

3.9.2

Debug accessory mode detection

The STUSB1602 detects a connection to a debug and test system (DTS) when it operates

either in sink power role or in source power role. The debug accessory detection is

advertised by the DEBUG1 and DEBUG2 pins as well as through the

CC_ATTACHED_MODE bits of the I2C register CC_CONNECTION_STATUS.

•

In sink power role, a debug accessory device is detected when both the CC1 and CC2

pins are pulled up by an Rp resistor from the connected device. The voltage levels on

the CC1 and CC2 pins give the orientation and current capability as described in the

table below. The DEBUG1 pin is asserted to advertise the DTS detection and the

A_B_SIDE pin indicates the orientation of the connection. The current capability of the

DTS is given through the SINK_POWER_STATE bits of the I2C register

CC_OPERATION_STATUS.

STUSB1602 Arkusz danych(PDF) 21 Page - STMicroelectronics