AD7734 datasheet(13/32 Pages) AD

13 / 32 page

AD7734

Pin No.

Mnemonic

Description

INTBIAS

This pin provides direct access to the analog input’s common node, bypassing the input

resistor divider. In normal circuit configuration, this pin is left open circuit.

MUX0

This pin provides direct access to the multiplexer input of Channel 0, bypassing the

input resistor divider. The input voltage range is 0 V to +0.625 V, ±0.625 V, 0 V to +1.25 V,

or ±1.25 V referenced to the INTBIAS pin. In normal circuit configuration, this pin is left

open circuit.

11, 14, 15, 18

BIAS0–BIAS3

These inputs are used to level shift the analog inputs. These signals are used to ensure

that the differential signal seen by the internal buffer amplifier is within its common-

mode range. The BIAS0 to BIAS3 pins will normally be connected to 2.5 V.

12, 13, 16, 17

AIN0–AIN3

Analog Inputs.

BIASLO

BIASLO, in association with BIASHI, is used to set the analog input common-mode

voltage. Assuming the BIAS0 to BIAS3 and BIASHI pins are connected to 2.5 V, the analog

input voltages are referenced to the voltage at BIASLO. In normal circuit configuration,

this pin should be connected to 0 V.

BIASHI

BIASHI, in association with BIASLO, is used to set the analog input common-mode

voltage. In normal circuit configuration, this pin should be connected to 2.5 V.

REFIN(+)

Positive Terminal of the Differential Reference Input. REFIN(+) voltage potential can lie

anywhere between AVDD and AGND. In normal circuit configuration, this pin should be

connected to a 2.5 V reference voltage.

REFIN(–)

Negative Terminal of the Differential Reference Input. REFIN(–) voltage potential can lie

anywhere between AVDD and AGND. In normal circuit configuration, this pin should be

connected to a 0 V reference voltage.

AGND

Ground Reference Point for Analog Circuitry.

RDY

Logic Output. Used as a status output in both conversion mode and calibration mode. In

conversion mode, a falling edge on this output indicates that either any channel or all

channels have unread data available, according to the RDYFN bit in the I/O port register.

In calibration mode, a falling edge on this output indicates that calibration is complete

(see the Digital Interface Description section for more details).

DOUT

Serial data output with serial data being read from the output shift register on the part.

This output shift register can contain information from any AD7734 register, depending

on the address bits of the communications register.

DIN

Serial data input (Schmitt triggered) with serial data being written to the input shift

DVDD

Digital Supply Voltage, 3 V or 5 V Nominal.

DGND

Ground Reference Point for Digital Circuitry.

Rev. 0 | Page 13 of 32

AD7734 Arkusz danych(PDF) 13 Page - Analog Devices

AD7734 Arkusz danych(HTML) 13 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Arkusz danych Pobierz

Link URL