HCS08 datasheet(49/290 Pages) MOTOROLA

49 / 290 page

Data Sheet — MC9S08GB60/D V1.5

MOTOROLA

MC9S08GB/GT

When security is enabled, the RAM is considered a secure memory resource and is not accessible through

BDM or through code executing from non-secure memory. See section 4.5 Security for a detailed

description of the security feature.

4.4 FLASH

The FLASH memory is intended primarily for program storage. In-circuit programming allows the

operating program to be loaded into the FLASH memory after final assembly of the application product.

It is possible to program the entire array through the single-wire background debug interface. Because no

special voltages are needed for FLASH erase and programming operations, in-application programming

is also possible through other software-controlled communication paths. For a more detailed discussion of

in-circuit and in-application programming, refer to the HCS08 Family Reference Manual, Volume I,

Motorola document order number HCS08RMv1/D.

4.4.1 Features

Features of the FLASH memory include:

•

FLASH Size

–

MC9S08GB/GT60 — 61268 bytes (120 pages of 512 bytes each)

–

MC9S08GB/GT32 — 32768 bytes (64 pages of 512 bytes each)

•

Single power supply program and erase

•

Command interface for fast program and erase operation

•

Up to 100,000 program/erase cycles at typical voltage and temperature

•

Flexible block protection

•

Security feature for FLASH and RAM

•

Auto power-down for low-frequency read accesses

4.4.2 Program and Erase Times

Before any program or erase command can be accepted, the FLASH clock divider register (FCDIV) must

be written to set the internal clock for the FLASH module to a frequency (fFCLK) between 150 kHz and

200 kHz (see 4.6.1 FLASH Clock Divider Register (FCDIV)). This register can be written only once, so

normally this write is done during reset initialization. FCDIV cannot be written if the access error flag,

FACCERR in FSTAT, is set. The user must ensure that FACCERR is not set before writing to the FCDIV

and erase pulses. An integer number of these timing pulses are used by the command processor to complete

a program or erase command.

HCS08 Arkusz danych(PDF) 49 Page - Motorola, Inc

HCS08 Arkusz danych(HTML) 49 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Arkusz danych Pobierz

Link URL