| Zakładka z wyszukiwarką danych komponentów |
|
AS3701 Arkusz danych(PDF) 29 Page - ams-OSRAM AG |
|
|
|||||||||||||||||||||||||||||
AS3701 Arkusz danych(HTML) 29 Page - ams-OSRAM AG |
|
29 / 110 page ![]() Page 28 ams Datasheet Document Feedback [v1-11] 2016-Dec-14 AS3701 − Detailed Description – Power Management Functions Figure 33: NTC Supervision Configuration Note(s): 1. If no NTC supervision is selected, all NTC relevant bits are ineffective 2. AS3701B only NTC Resistor Depending on the used resistor value of the NTC (10k or 100k) the internal NTC current (150 μA for 10k or 15μA for 100k) can be selected via ntc_10k [ChargerSupervision]. High/Low Temperature The battery high temperature supervision is controlled with the bit ntc_high_on [ChargerSupervision] and this feature is enabled per default. If the temperature is higher than 45°C or 60°C (depending on ntc_mode [ChargerSupervision]) the flag temp_ cond [ChargerStatus1] will be set and the charger will stop operation. When the battery temperature drops and the voltage on NTC pin rises above VBATTEMP_HIGH_OFF, the flag temp_cond will be reset and the charger will continue with the charging again. The battery low temperature supervision is controlled with the bit ntc_low_on [ChargerSupervision] and this feature is disabled per default. If the temperature is lower than 0°C the flag temp_ cond [ChargerStatus1] will be set and the charger will stop operation. When the battery temperature rises and the voltage on NTC pin falls below VBATTEMP_LOW_OFF, the flag temp_cond will be reset and the charger will continue with the charging again. The detection of a high or low battery temperature can also be indicated with a dedicated interrupt mask bit bat_temp_m [InterruptMask2]. For the high and low temperature supervision, a temperature hysteresis is included to avoid an oscillation of the charger. The supply for the NTC will be on when either the ntc_high_on or the ntc_low_on bit is set, no matter if a charger is detected or not. Therefore the battery temperature supervision can be used for charging mode and also for discharging mode. NTC_input NTC Supervision Configuration 00 No NTC supervision (1) 01 XIRQ_NTC pin 10 GPIO3 pin (2) 11 GPIO4 pin (2) |
|
Link URL |
| Czy Alldatasheet okazała się pomocna? [ DONATE ] |
O Alldatasheet | Reklama | Kontakt | Polityka prywatności | Link do karty katalogowej | Linki | Lista producentów All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |