AT25DF321 datasheet(18/37 Pages) ATMEL

18 / 37 page

3669A–DFLASH–07/07

AT25DF321

Figure 9-5.

Read Sector Protection Register

9.7

Protected States and the Write Protect (WP) Pin

The WP pin is not linked to the memory array itself and has no direct effect on the protection sta-

tus of the memory array. Instead, the WP pin, in conjunction with the SPRL (Sector Protection

Registers Locked) bit in the Status Register, is used to control the hardware locking mechanism

of the device. For hardware locking to be active, two conditions must be met – the WP pin must

be asserted and the SPRL bit must be in the logical “1” state.

When hardware locking is active, the Sector Protection Registers are locked and the SPRL bit

itself is also locked. Therefore, sectors that are protected will be locked in the protected state,

and sectors that are unprotected will be locked in the unprotected state. These states cannot be

changed as long as hardware locking is active, so the Protect Sector, Unprotect Sector, and

Write Status Register commands will be ignored. In order to modify the protection status of a

sector, the WP pin must first be deasserted, and the SPRL bit in the Status Register must be

reset back to the logical “0” state using the Write Status Register command. When resetting the

SPRL bit back to a logical “0”, it is not possible to perform a Global Protect or Global Unprotect

at the same time since the Sector Protection Registers remain soft-locked until after the Write

Status Register command has been executed.

If the WP pin is permanently connected to GND, then once the SPRL bit is set to a logical “1”,

the only way to reset the bit back to the logical “0” state is to power-cycle or reset the device.

This allows a system to power-up with all sectors software protected but not hardware locked.

Therefore, sectors can be unprotected and protected as needed and then hardware locked at a

later time by simply setting the SPRL bit in the Status Register.

When the WP pin is deasserted, or if the WP pin is permanently connected to V

CC, the SPRL bit

in the Status Register can still be set to a logical “1” to lock the Sector Protection Registers. This

provides a software locking ability to prevent erroneous Protect Sector or Unprotect Sector com-

mands from being processed. When changing the SPRL bit to a logical “1” from a logical “0”, it is

also possible to perform a Global Protect or Global Unprotect at the same time by writing the

appropriate values into bits 5, 4, 3, and 2 of the Status Register.

SCK

MSB

00111100

410 11

812

37 38

31 32

29 30

39 40

OPCODE

AAAA

AAA

MSB

DDDDDDD

ADDRESS BITS A23-A0

DATA BYTE

HIGH-IMPEDANCE

AT25DF321 Arkusz danych(PDF) 18 Page - ATMEL Corporation

AT25DF321 Arkusz danych(HTML) 18 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Arkusz danych Pobierz

Link URL