AT25DF321 datasheet(26/37 Pages) ATMEL

26 / 37 page

3669A–DFLASH–07/07

AT25DF321

11.3

Resume from Deep Power-Down

In order exit the Deep Power-Down mode and resume normal device operation, the Resume

from Deep Power-Down command must be issued. The Resume from Deep Power-Down com-

mand is the only command that the device will recognize while in the Deep Power-Down mode.

To resume from the Deep Power-Down mode, the CS pin must first be asserted and opcode of

ABh must be clocked into the device. Any additional data clocked into the device after the

opcode will be ignored. When the CS pin is deasserted, the device will exit the Deep Power-

Down mode within the maximum time of t

RDPD and return to the standby mode. After the device

has returned to the standby mode, normal command operations such as Read Array can be

resumed.

If the complete opcode is not clocked in before the CS pin is deasserted, or if the CS pin is not

deasserted on an even byte boundary (multiples of eight bits), then the device will abort the

operation and return to the Deep Power-Down mode.

Figure 11-3. Resume from Deep Power-Down

SCK

MSB

ICC

10101011

OPCODE

HIGH-IMPEDANCE

Deep Power-Down Mode Current

Active Current

Standby Mode Current

tRDPD

AT25DF321 Arkusz danych(PDF) 26 Page - ATMEL Corporation