Regulatory compliance

SP1ML

24/27

DocID026906 Rev 4

The OEM must include the following statements on the exterior of the final product unless

the product is too small (e.g. less than 4 x 4 inches):

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including any interference that may

cause undesired operation.

6.4

Product manual instructions

This section applies to OEM final products containing the SP1ML-915 module, subject to

FCC compliance. The final product manual must contain the following statement (or a

similar statement that conveys the same meaning):

WARNING: Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment

In cases where an OEM seeks Class B (residential) limits for the final product, the following

statement must be included in the final product manual:

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

–

Reorient or relocate the receiving antenna.

–

Increase the separation between the equipment and receiver.

–

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

–

Consult the dealer or an experienced radio/TV technician for help.

In cases where an OEM seeks the lesser category of a Class A digital device for the final

product, the following statement must be included in the final product manual:

NOTE: This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his expense.