AP0101CS datasheet(29/42 Pages) ONSEMI

29 / 42 page

AP0101CS/D Rev. 7, 1/16 EN

©Semiconductor Components Industries, LLC,2016.

AP0101CS HDR: Image Signal Processor (ISP)

Protocol

The SADDR pin is used to select between two different addresses in case of conflict with

another device. If SADDR is LOW, the slave address is 0x90; if SADDR is HIGH, the slave

address is 0xBA. See Table 17 below. The user can change the slave address by changing a

Start Condition

A start condition is defined as a HIGH-to-LOW transition on SDATA while SCLK is HIGH.

At the end of a transfer, the master can generate a start condition without previously

generating a stop condition; this is known as a “repeated start” or “restart” condition.

Data Transfer

Data is transferred serially, 8 bits at a time, with the MSB transmitted first. Each byte of

data is followed by an acknowledge bit or a no-acknowledge bit. This data transfer

mechanism is used for the slave address/data direction byte and for message bytes. One

data bit is transferred during each SCLK clock period. SDATA can change when SCLK is low

and must be stable while SCLK is HIGH.

Slave Address/Data Direction Byte

Bits [7:1] of this byte represent the device slave address and bit [0] indicates the data

transfer direction. A “0” in bit [0] indicates a write, and a “1” indicates a read. The default

slave addresses used by the AP0101CS are 0x90 (write address) and 0x91 (read address).

Alternate slave addresses of 0xBA (write address) and 0xBB (read address) can be

selected by asserting the SADDR input signal.

Message Byte

Message bytes are used for sending register addresses and register write data to the slave

device and for retrieving register read data. The protocol used is outside the scope of the

two-wire serial interface specification.

Acknowledge Bit

Each 8-bit data transfer is followed by an acknowledge bit or a no-acknowledge bit in the

SCLK clock period following the data transfer. The transmitter (which is the master when

writing, or the slave when reading) releases SDATA. The receiver indicates an acknowl-

edge bit by driving SDATA LOW. As for data transfers, SDATA can change when SCLK is

LOW and must be stable while SCLK is HIGH.

No-Acknowledge Bit

The no-acknowledge bit is generated when the receiver does not drive SDATA low during

the SCLK clock period following a data transfer. A no-acknowledge bit is used to termi-

nate a read sequence.

Table 17:

Two-Wire Interface ID Address Switching

SADDR

Two-Wire Interface Address ID

00x90

10xBA

AP0101CS Arkusz danych(PDF) 29 Page - ON Semiconductor

AP0101CS Arkusz danych(HTML) 29 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Arkusz danych Pobierz

Link URL