MCP3913 datasheet(20/82 Pages) MICROCHIP

20 / 82 page

MCP3913

DS20005227A-page 20

 2013 Microchip Technology Inc.

3.14

Master Reset (RESET)

This pin is active low and places the entire chip in a

Reset state when active.

When RESET is logic low, all registers are reset to their

default value, no communication can take place, and

no clock is distributed inside the part, except in the

input structure if MCLK is applied (if MCLK is idle, then

no clock is distributed). This state is equivalent to a

Power-On Reset (POR) state.

Since the default state of the ADCs is on, the analog

power consumption when RESET is logic low is

equivalent to when RESET is logic high. Only the digital

power consumption is largely reduced because this

current consumption is essentially dynamic, and is

reduced drastically when there is no clock running.

All the analog biases are enabled during a Reset, so

that the part is fully operational just after a RESET

rising edge, if MCLK is applied when RESET is logic

low. If MCLK is not applied, there is a time after a hard

reset when the conversion may not accurately

correspond to the startup of the input structure.

This input is Schmitt-triggered.

3.15

Digital Power Supply (DVDD)

DVDD is the power supply voltage for the digital circuitry

within the MCP3913. It is distributed on several pins

(pins 20 and 33 in the UQFN package, one pin only in

the SSOP-28 package). For optimal performance, it is

recommended to connect these pins together using a

star connection and to connect appropriate bypass

capacitors (typically a 10 µF in parallel with a 0.1 µF

ceramic). DVDD should be maintained between 2.7V

and 3.6V for specified operation.

At least one of these pins need to be properly con-

nected to ensure proper functionality of the device. All

of these pins need to be properly connected to ensure

optimal performance of the device. If any of these pins

are left floating, the accuracy and noise specifications

are not ensured.

3.16

Exposed Thermal Pad

This pin must be connected to AGND or left floating for

proper operation. Connecting it to AGND is preferable

for lowest noise performance and best thermal

behavior.

MCP3913 Arkusz danych(PDF) 20 Page - Microchip Technology

MCP3913 Arkusz danych(HTML) 20 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

Arkusz danych Pobierz

Link URL