AD10265SLASHPCB datasheet(6/18 Pages) AD

6 / 18 page

AD10265

–6–

REV. 0

Output Propagation Delay

The delay between the 50% point of the rising edge of ENCODE

command and the time when all output data bits are within

valid logic levels.

Power Supply Rejection Ratio

The ratio of a change in input offset voltage to a change in

power supply voltage.

Signal-to-Noise-and-Distortion (SINAD)

The ratio of the rms signal amplitude (set at 1 dB below full

scale) to the rms value of the sum of all other spectral compo-

nents, including harmonics but excluding dc.

Signal-to-Noise Ratio (without Harmonics)

The ratio of the rms signal amplitude (set at 1 dB below full

scale) to the rms value of the sum of all other spectral compo-

nents, excluding the first five harmonics and dc.

Spurious-Free Dynamic Range

The ratio of the rms signal amplitude to the rms value of the

peak spurious spectral component. The peak spurious compo-

nent may or may not be a harmonic. May be reported in dBc

(i.e., degrades as signal levels is lowered) or in dBFS (always

related back to converter full scale).

Two-Tone Intermodulation Distortion Rejection

The ratio of the rms value of either input tone to the rms value

of the worst third order intermodulation product; reported in

dBc.

Two-Tone SFDR

The ratio of the rms value of either input tone to the rms value

of the peak spurious component. The peak spurious compo-

nent may or may not be an IMD product. May be reported

in dBc (i.e., degrades as signal levels is lowered) or in dBFS

(always related back to converter full scale).

DEFINITION OF SPECIFICATIONS

Analog Bandwidth

The analog input frequency at which the spectral power of the

fundamental frequency (as determined by the FFT analysis) is

reduced by 3 dB.

Aperture Delay

The delay between the 50% point of the rising edge of the

ENCODE command and the instant at which the analog input

is sampled.

Aperture Uncertainty (Jitter)

The sample-to-sample variation in aperture delay.

Differential Nonlinearity

The deviation of any code from an ideal 1 LSB step.

Encode Pulse Width/Duty Cycle

Pulse width high is the minimum amount of time that the

ENCODE pulse should be left in logic “1” state to achieve rated

performance; pulse width low is the minimum time ENCODE

pulse should be left in low state. At a given clock rate, these

specs define an acceptable Encode duty cycle.

Harmonic Distortion

The ratio of the rms signal amplitude to the rms value of the

worst harmonic component.

Integral Nonlinearity

The deviation of the transfer function from a reference line

measured in fractions of 1 LSB using a “best straight line” de-

termined by a least square curve fit.

Minimum Conversion Rate

The encode rate at which the SNR of the lowest analog signal

frequency drops by no more than 3 dB below the guaranteed

limit.

Maximum Conversion Rate

The encode rate at which parametric testing is performed.

AD10265/PCB Arkusz danych(PDF) 6 Page - Analog Devices

AD10265/PCB Arkusz danych(HTML) 6 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Arkusz danych Pobierz

Link URL