UM0244

Software

7/11

1.

Connect the “Flying Lead” cable, or a ribbon cable to the FlashLINK Adaptor, and also

connect it to your target circuit board just as if you are ready to program the device.

2.

Turn on the power on the target device, and then click the “Connect Test” button in the

“HW Setup” dialog screen.

This test involves the circuit traces on your circuit board. If there is a failure, it is likely due to

signal routing or signal integrity on the target circuit board, or the PC may have compatibility

problems with the parallel port driver used by CAPS.

Note:

If either test fails, you will see a window pop-up that allows you to email in the problem.

Please do so and we will assist you.