TUSB2136PM datasheet(35/50 Pages) TI

35 / 50 page

2–23

2.9.4

Logical Interrupt Connection Diagram (INT0)

Figure 2–4 represents the logical connection of the interrupt sources and the relation of the logical connection with

INT0. The priority encoder generates an 8-bit vector, corresponding to 64 interrupt sources (not all are used). The

interrupt priorities are hard wired. Vector 46h is the highest and 12h is the lowest. Table 2–8 lists the interrupt source

for each valid interrupt vector.

Interrupts

INT0

Priority

Encoder

Vector

Interrupt Sources

46h

12h

Figure 2–4. Internal Vector Interrupt (INT0)

2.9.5

P2[7:0] Interrupt (INT1)

Figure 2–5 illustrates the conceptual port-2 interrupt. All port-2 input signals are connected in a logical OR to generate

the INT1 interrupt. Note that the inputs are active low and INT1 is programmed as a level-triggered interrupt. In

addition, INT1 is connected to the suspend/resume logic for remote wake-up support. As illustrated, the XINT bit in

the MCU configuration register (MCNFG) is used to select the EX1 interrupt source. When XINT = 0, P3.3 is the

source, and when XINT = 1, P2[7:0] is the source.

Suspend/

Resume

Logic

P2[7:0]

P3.3

INT1

XINT Bit

Figure 2–5. P2[7:0] Input Port Interrupt Generation

TUSB2136PM Arkusz danych(PDF) 35 Page - Texas Instruments