| Zakładka z wyszukiwarką danych komponentów |
|
ST25R3916 Arkusz danych(PDF) 18 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST25R3916 Arkusz danych(HTML) 18 Page - STMicroelectronics |
|
18 / 157 page ![]() Description ST25R3916/7 18/157 DS12484 Rev 4 2.2.12 TX encoding This block encodes the transmit frames according to the selected RF mode and bit rate. The SOF (start of frame), EOF (end of frame), CRC and parity bits are generated automatically. The data to transmit are taken from the FIFO. In Stream mode the framing is bypassed. The FIFO data directly defines the modulation data sent to the transmitter. In Transparent mode, the framing and FIFO are bypassed, and the MOSI pin directly drives the modulation of the transmitter. 2.2.13 RX decoding This block decodes received frames according to the selected RF mode and bitrate. The SOF (start of frame), EOF (end of frame), CRC and parity bits are automatically checked, all of them (except the CRC bit) are removed by this block. The received data is written to the FIFO. In Stream mode the framing is bypassed. The digitized subcarrier signal is directly stored in the FIFO. In Transparent mode the framing and FIFO are bypassed. The digitized subcarrier signal directly drives the MISO pin. 2.2.14 FIFO The ST25R3916/7 contain a 512-byte FIFO. Depending on the direction of the data transfer, it contains either data which has been received or data which is to be transmitted. In reader mode the ST25R3916/7 can transmit frames of up to 8191 bytes length and receive frames of arbitrary length. 2.2.15 Control logic The control logic contains I/O registers that define the operation of device. 2.2.16 Host interface A 4-wire serial peripheral interface (SPI) and a 2-wire I2C interface are available to communicate with an external microcontroller. The pins for the SPI and the I2C interface are shared, and pin I2C_EN is used to select the active interface. 2.2.17 Passive target memory The devices contain a 48-byte RAM to store configuration data for the passive target and card emulation mode. 2.2.18 P2RAM The P2RAM stores information on wafer number, die position, device subversion, and I2C address. The P2RAM is programmed during production. |
|
Link URL |
| Czy Alldatasheet okazała się pomocna? [ DONATE ] |
O Alldatasheet | Reklama | Kontakt | Polityka prywatności | Link do karty katalogowej | Linki | Lista producentów All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |