IMX8MPCEC datasheet(4/111 Pages) NXP

4 / 111 page

i.MX 8M Plus Applications Processor Datasheet for Consumer Products, Rev. 0, 03/2021

NXP Semiconductors

i.MX 8M Plus introduction

Audio

• Cadence® Tensilica® HiFi 4 DSP, operating up to 800 MHz

• SPDIF input and output, including a raw capture input mode

• Six external synchronous audio interface (SAI) modules supporting I2S, AC97,

TDM, codec/DSP, and DSD interfaces, comprising one SAI with 8 TX and 8 RX

lanes, one SAI with 4 TX and 4 RX lanes, two SAI with 2 TX and 2 RX lanes, and

two SAI with 1 TX and 1RX lane.

• All ports support 49.152 MHz BCLK.

• ASRC supports processing 32 audio channels, 4 context groups, 8 kHz to 384 kHz

sample rate, and 1/16 to 8x sample rate conversion ratio.

• eARC/ARC

• 8-channel PDM mic input

GPIO and pin multiplexing

General-purpose input/output (GPIO) modules with interrupt capability

Input/output multiplexing controller (IOMUXC) to provide centralized pad control

Power management

Temperature sensor with programmable trip points

Flexible power domain partitioning with internal power switches to support efficient

power management

Connectivity

One PCIe Express (PCIe) Single Lane supporting PCIe Gen3

• Dual Mode operation to function as root complex or endpoint

• Integrated PHY interface

• Supports L1 low power sub-state

Two USB 3.0 Type C controllers with integrated PHY (also supported USB 2.0)

interfaces:

• Spread spectrum clock support

Three Ultra Secure Digital Host Controller (uSDHC) interfaces

• eMMC 5.1 compliance with HS400 DDR signaling to support up to 400 MB/sec

• SD/SDIO 3.0 compliance with 200 MHz SDR signaling to support up to 100

MB/sec

• Support for SDXC (extended capacity)

Two Ethernet controllers (both capable of simultaneous operation)

• One Gigabit Ethernet controller with support for Energy Efficient Ethernet (EEE),

Ethernet AVB, and IEEE 1588

• One Gigabit Ethernet controller with support for TSN in addition to EEE, Ethernet

AVB, and IEEE 1588

Two Controller Area Network (FlexCAN) modules, each optionally supporting flexible

data-rate (FD)

Note: Legacy CAN mode supports both Mailbox (MB) and RX FIFO (with DMA

support) operation. Flexible Data (FD) mode supports MB operation only. There is no

enhanced RX FIFO or DMA support in FD mode.

Four Universal Asynchronous Receiver/Transmitter (UART) modules

Six I2C modules

Three SPI modules

Table 1. Features (continued) (Sheet 3 of 4)

Subsystem

Features

IMX8MPCEC Arkusz danych(PDF) 4 Page - NXP Semiconductors

IMX8MPCEC Arkusz danych(HTML) 4 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Arkusz danych Pobierz

Link URL