T48C862-R8 datasheet(33/107 Pages) ATMEL

33 / 107 page

T48C862-R8

4590B–4BMCU–02/03

Bi-directional Ports

With the exception of Port 1 and Port 6, all other ports (2, 4 and 5) are 4 bits wide. Port 1

and Port 6 have a data width of 2 bits (bit 0 and bit 3). All ports may be used for data

input or output. All ports are equipped with Schmitt trigger inputs and a variety of mask

options for open-drain, open-source, full-complementary outputs, pull-up and pull-down

transistors. All Port Data Registers (PxDAT) are I/O mapped to the primary address reg-

ister of the respective port address and the Port Control Register (PxCR), to the

corresponding auxiliary register.

There are five different directional ports available:

Port 1

2-bit wide bi-directional port with automatic full bus width direction switching.

Port 2

4-bit wide bitwise-programmable I/O port.

Port 5

4-bit wide bitwise-programmable bi-directional port with optional strong

pull-ups and programmable interrupt logic.

Port 4

4-bit wide bitwise-programmable bi-directional port also provides the I/O

interface to Timer 2, SSI, voltage monitor input and external interrupt input.

Port 6

2-bit wide bitwise-programmable bi-directional port also provides the I/O

interface to Timer 3 and external interrupt input.

Bi-directional Port 1

In Port 1 the data direction register is not independently software programmable, the

direction of the complete port being switched automatically when an I/O instruction

occurs (see Figure 27). The port is switched to output mode via an OUT instruction and

to input via an IN instruction. The data written to a port will be stored into the output data

latches and appears immediately at the port pin following the OUT instruction. After

RESET all output latches are set to "1" and the port is switched to input mode. An IN

instruction reads the condition of the associated pins.

Note:

Care must be taken when switching the bi-directional port from output to input. The

capacitive pin loading at this port in conjunction with the high resistance pull-ups may

cause the CPU to read the contents of the output data register rather than the external

input state. To avoid this, one of the following programming techniques should be used:

Use two IN-instructions and DROP the first data nibble. The first IN switches the port

from output to input and the DROP removes the first invalid nibble. The second IN reads

the valid pin state.

Use an OUT-instruction followed by an IN-instruction. Via the OUT-instruction, the capac-

itive load is charged or discharged depending on the optional pull-up/pull-down

configuration. Write a "1" for pins with pull-up resistors and a "0" for pins with pull-down

resistors.

T48C862-R8 Arkusz danych(PDF) 33 Page - ATMEL Corporation

T48C862-R8 Arkusz danych(HTML) 33 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Arkusz danych Pobierz

Link URL