ATmega165 datasheet(91/336 Pages) ATMEL

91 / 336 page

ATmega165/V

2573G–AVR–07/09

16-bit

Timer/Counter1

The 16-bit Timer/Counter unit allows accurate program execution timing (event man-

agement), wave generation, and signal timing measurement. The main features are:

• True 16-bit Design (i.e., Allows 16-bit PWM)

• Two independent Output Compare Units

• Double Buffered Output Compare Registers

• One Input Capture Unit

• Input Capture Noise Canceler

• Clear Timer on Compare Match (Auto Reload)

• Glitch-free, Phase Correct Pulse Width Modulator (PWM)

• Variable PWM Period

• Frequency Generator

• External Event Counter

• Four independent interrupt Sources (TOV1, OCF1A, OCF1B, and ICF1)

Overview

Most register and bit references in this section are written in general form. A lower case

“n” replaces the Timer/Counter number, and a lower case “x” replaces the Output Com-

pare unit number. However, when using the register or bit defines in a program, the

precise form must be used, i.e., TCNT1 for accessing Timer/Counter1 counter value

and so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in Figure 40. For the

actual placement of I/O pins, refer to “Pinout ATmega165” on page 2. CPU accessible

I/O Registers, including I/O bits and I/O pins, are shown in bold. The device-specific I/O

on page 113.

The PRTIM1 bit in “Power Reduction Register - PRR” on page 34 must be written to

zero to enable Timer/Counter1 module

ATmega165 Arkusz danych(PDF) 91 Page - ATMEL Corporation